Facebook Click here to find out more!
 

Streetable Rear Gears For Your '61-'69 8 3/4-inch Rear End

Nitro Gear & Axle, Just Differentials, "742" case 8/3/4-inch rear end
Posted January 3 2012 09:12 AM by Scott Ross 
Filed under: Miscellaneous, SCOTT ROSS

No Subject

Got a muscle Mopar with a 8 3/4-inch rear end with a "742" casting number on it? And are you're looking for a taller rear gear set so you're not going down the road at 70 mph turning over 3000 rpm? 


Check out this new 3.23 gear set from Nitro Gear & Axle...


Nitro Gear & Axle's new 3.23:1 ring and pinion gear set is the aftermarket's first one that'll fit inside the 1961-69 vintage  "742"-case 8 3/4-inch rear ends. (Until now, 3.55's have been the most streetable aftermarket gear set you could find for that case, known for its large-- 1 3/4-inch diameter--pinion.)

No Subject

The ring and pinion gears are made of better-than-OEM steels, then machined, heat-treated and lapped using state-of-the-art equipment, and then thoroughly inspected before they're shipped to you, ready to install.

Got a "489" or a "741" 8 3/4-inch rear end? Nitro Gear & Axle has ring and pinion sets, and install kits, for them, too.

MORE INFO: Nitro Gear & Axle, www.nitro-gear.com
GET IT: www.justdifferentials.com (Nitro Axle & Gear's US distributor)


(Courtesy Nitro Gear & Axle)



0 comments
  • RSS Feed
    • Add to My Yahoo!
    • Add to Google
    • Subscribe on Bloglines
    • Subscribe on NewsGator
    • MyMSN
    • My AOL
    • Add to NetVibes
    • Add to Rojo
    • Add to NEWSBURST
    • Add to Technorati
    SUBSCRIBE TO OUR BLOGS


Mopar Muscle
Mopar Muscle Magazine